DailyPost
close
Breaking news

1SHARESShareTweet There are good vacat...read more 0SHARESShareTweet All roads lead to Ro...read more 1SHARESShareTweet My blogging is real....read more

How to glue wallpaper at the corners: instructions, gluing outer, inner corner, docking

Step by step directions to gluing inner corners

After completing, the principal problem can be uneven walls as well as the consequent folds on the wallpaper. It’s also necessary to take into consideration that when the walls are twisted , the joints of wallpaper canvases might invisibly.

After gluing the last one in front of the interior corner of the cloth must measure the remaining space. It is measured from the border of the pasted cloth to the adjacent wall, and the resulting amount is added 10-15 millimeters. When the walls are extremely curved, the extra figure could be more.

Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces have been treated with adhesive. Depending on the form of coat it could be exactly the wall or the surfaces.

The strip is glued independently with the cut side to the wallsocket. The background should go on the other airplane.

In case the glued background is sterile, then you want to make several modest cuts perpendicular to the springs.

Level or slope on the adjacent wall is a vertical lineup. The distance in the corner is equal to the width of the prior cut strip, not including developments.

The surfaces have been smeared with adhesive, and the coating is glued to the wall using the flat side to the marked line. The cut side goes on the adjoining wall.

Protruding corner ought to be glued by analogy using the interior, but there are little gaps, which also have to be taken into account when working.

Measured the space remaining out of the glued background to the adjacent wall. Add 20-25 millimeters to the obtained figure.

A section is cut off, considering the additional 20-25 millimeters.

Prior to gluing, the surfaces are treated with glue.

The even edge has to be glued to the wallpaper already fixed onto the walls, your own cut side”extends” into the adjacent plane. If necessary, small cuts are created in the place of visiting the other background, smoothed and pressed to the wall.

Draw a vertical strip onto the adjacent wall in a distance of only glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is applied to the wall using its flat side to the marked line, going over the edge of this already glued gidpola.ru strip.

The joints have been smeared with glue and ironed with a roller. Following that, the upper layer is cut across the ruler and the 2 layers are joined together.

No Comments

Leave a reply

Post your comment
Enter your name
Your e-mail address

Story Page