A corner apartment is located at the end of the construction: that is, part of its walls are not adjacent to the neighbours, however are the outer partitions of the house.
There might be one apartment at a corner apartment – it occupies the whole end of the home, it’s also referred to as a corner flat. Or 2 – the windows of a overlook the street, the next – the lawn. Depends on the building program, the design of the assumptions.
There is also a”different caste” – housing with walls at the expansion joints. Such”gaps” between entrances are normally made in multi-story structures, the most important job of the created unit – to break the deformation forces through the shrinkage of the building, in the event of crises. Pros and cons of corner apartments in the joint are somewhat different from the typical ones with access to the road – we will pay special attention to the subject in the past section.
Because the 2-3 sides of this space is outdoors, in winter it’s 3-5C colder, and in summertime on the contrary – warmer. Especially if the end of the house is heated by the sun. Sometimes, the gap reaches 10C – but such a difference is improper, indicates that a problem with the outside the house – most probably have to get hold of the management firm, requesting (or forcing) to meet their direct duties, to spot the cracks shaped.
Corner apartment in a brick home with thick walls is much more comfy. Such dangers are not exposed – the depth of the wall acts as a buffer, not allowing overheating, overcooling.
When an area has just 1 wall united with the road, it generally has enough space warmth to prevent freezing and condensation. But when there are two outside walls, and they’re adjacent – there’s a high probability of freezing at the corner, the creation of condensation in it, and therefore – mould, fungus. Their spores not just spoil the overall look of the room, domikday.ru but also cause the look, complication of many serious ailments.
Important! The problems of corner place are justified when the factors are linked – too low temperatures from heating batteries along with dampness is sure to result in moldy walls.